Chinese translation for "cavity thickness"

空泡稠密度

Related Translations:

interchangeable cavity:  互换式型腔

collar cavity:  领腔

cavity pistonpiston:  凹头活塞

splanchnic cavity:  内脏腔体腔

rinse cavity:  洗洞

cavity well:  洞穴井阴模模腔

cavity blemish:  空洞缺陷

cavity resonance:  空腔共振空腔谐振

brachial cavity:  臂室腕骨腔

serous cavity:  浆液膜腔。

Example Sentences:

	1.	The influence of the injection pressure to the mold cavity thickness was analyzed , formulas of circular mold cavity thickness were calculated , providing theory basis for deciding the mold cavity dimension rightly 摘要分析了注射压力对模具型腔壁厚的影响，推导了圆形型腔壁厚的计算公式，为合理确定注射模具型腔壁厚提供了理论依据。
	2.	Presently most of the theoretical method to predict the propeller - induced hull pressure fluctuation is based on the calculation method in which the pressure is induced by pulsating source in infinite flow . the calculation method is adopted and the corresponded computer program is complied . the propeller - induced hull pressure fluctuation due to blade thickness , blade load , cavity thickness and the change of the cavity volume can be analyzed respectively in the computer program 目前，螺旋桨诱导的船体表面脉动压力的理论预报方法，大多是以无限流场中点脉动源诱导的周围流场的脉动压力的计算方法为基础的，本文采用该方法编制了计算程序，可以分别考虑桨叶厚度、桨叶负荷、桨叶上空泡厚度及其体积变化在船体表面指定位置上产生的脉动压力。
	3.	Simulation and the associated numerical algorithm on the injection - compression molding ( icm ) process were developed to understand processing characteristics by changing processing parameters including compression speed , switch time from injection to compression , compression stroke as well as initial cavity thickness and part thickness using disk parts 摘要射出压缩成型的仿真以及数值运算是要了解成型参数的改变，包括：压缩速度、射出与封装的切换时间、压缩行程等制程特性而创建的，同时也包含了初始的开模厚度以及使用在光盘片的成品厚度。
	4.	Simulation and the associated numerical algorithm on the injection - compression molding ( icm ) process were developed to understand processing characteristics by changing processing parameters including compression speed , switch time from injection to compression , compression stroke as well as initial cavity thickness and part thickness using disk parts 摘要射出压缩成型的模拟以及数值运算是要了解成型参数的改变，包括：压缩速度、射出与压缩的切换时间、压缩行程等制程特性而建立的，同时也包含了初始的开模厚度以及使用在光碟片的成品厚度。

Similar Words：

"cavity support plate" Chinese translation, "cavity surface temperature" Chinese translation, "cavity temporary sealant" Chinese translation, "cavity termination" Chinese translation, "cavity theory" Chinese translation, "cavity toilet" Chinese translation, "cavity transfer mixer" Chinese translation, "cavity tripping" Chinese translation, "cavity tunable magnetron" Chinese translation, "cavity tuned retarding field tube" Chinese translation